Skip to content

Partner Academy · EcoBSS / FLEX

Fault 3P HV F56

BAT1_VoltLow_Fault

Energy storage 1 voltage too low

EcoBSS service: DC BUS / energy-storage voltage too low.

Register map

Family
Three-phase HV
Register
558
Bit
7

Field checks

  1. Check that energy-storage voltage is not too low.
  2. Check PV input voltage and ensure it is within the allowed range.
  3. Contact Inversol if the fault does not clear.

A BMS that still shows pack voltage while BAT is only a few volts usually means an open switch, a fuse, or a pack that has gone to sleep after a deep discharge.

For energy-storage pairing see LiFePO4 energy storage used with this inverter class.

FAQ

What does EcoBSS F56 mean?
Energy storage 1 voltage too low
What should I check for EcoBSS F56?
  1. Check that energy-storage voltage is not too low.
  2. Check PV input voltage and ensure it is within the allowed range.
  3. Contact Inversol if the fault does not clear.
When should I contact Inversol?
Confirm LV vs HV family on the nameplate, complete the field checks, then contact Inversol with model, SN, family, and a photo if the code returns after a clean power cycle.

Error won't clear? Send a photo of the display to WhatsApp +995 568 999 668: an Inversol engineer will tell you what to check.

Installer or service company? Deye, ECOBSS and Heckman equipment: partner prices on request via WhatsApp.

WhatsApp

Equipment for this class

This information is for reference only. Electrical work is performed by a qualified specialist in accordance with the manufacturer's instructions and local regulations. Code names are given per the ECOBSS manual for the stated series and may differ for your model.